On 16 November 2026 the US Federal Aviation Administration (FAA) published a proposed airworthiness directive for MBB-BK 117 C-1 and C-2 helicopters fitted, under a Supplemental Type Certificate, with an Air Comm Corporation air conditioning system (part number EC145-7040-1). The notice was signed on 10 November 2026; comments are due by 31 December 2026.
What the source reports
The FAA received reports of excessive corrosion on the condenser inlet duct. The corrosion allowed the internal support wire helix to break and protrude from the duct's silicone shell, and the wire struck the tail rotor drive shaft. If not addressed, this could cause failure of the drive shaft and loss of control of the helicopter.
The proposal would require, within 7 days of the effective date and then at intervals not exceeding 50 flight hours or 3 months, whichever is first: inspection of the drive shaft below the duct for protruding wire or wear; inspection of the duct exterior for a broken wire helix or bulging; a hand squeeze and flex test to check the duct returns to a circular shape; and a borescope inspection of the inside for corrosion of the wire helix, or for the inner silicone lining separating, bubbling or peeling. Depending on findings, the duct or the drive shaft would be replaced. The FAA estimates 54 helicopters on the US register are affected.
What it means for asset owners
In our view, the point is where the damage hides. The duct looked intact from outside, and the evidence was inside. Ask who chose the materials of parts classed as non-critical, and whether their inspection reaches the hidden surfaces.
Source: US Federal Aviation Administration, Federal Register, 16 November 2026.